Common problems and solutions of thermal imaging temperature measurement gate guard machine

Category:Industry News    Author:Administrators    Source:This website}    Release time:2021-04-29

After purchasing and installing the thermal imaging temperature measurement gate guard machine, some minor problems may occur due to improper operation or maintenance. Although it's not a big problem, it can also cause panic. Firstly, in order to prevent safety accidents, what issues should be paid attention to when repairing and maintaining safety inspection equipment?

 

1. There are a large number of devices with a working voltage of 220 volts; Daily maintenance must be carried out during power outages; If live working is required, it must be carried out by trained personnel; In addition, it is necessary to do a good job in preventing electric shock-

2. There are a large number of precision electronic devices inside the equipment, and preparations should be made to prevent static electricity from damaging the equipment before maintenance.

3. The device has a lead protective layer, which can prevent radiation leakage in many places. Wear cotton gloves while working; When you cannot wear gloves; Wash hands immediately after surgery.

Before powering on the device, please carefully check to ensure that the wiring is correct and there are no errors or short circuits.

Before turning on radiation, please cover it properly to avoid personal injury caused by radiation.

 

2、 How to solve the problem of the system not starting up for the thermal imaging temperature measurement gate guard machine?

 

1. Rotate the "emergency stop" button clockwise-

2. Check if the "key switch" is turned to the starting position-

3. Open the external panel of the device and check if the "air switch" has tripped;

4. Open the external panel of the device - check if the "fuse" is blown;

5. Open the external panel of the device - check if the AC contactor can be manually engaged.

 

3、 How to deal with the problem of conveyor belt not moving with the thermal imaging temperature measurement gate machine?

 

1. Check if there are any objects or dust blocking the "light blocking plate" in the channel;

2. Open the external panel of the device and check if the "motor protection switch" has tripped;

3. Check the "cable" connection from the controller to the motor control board. If loose, tighten again.

4. Check if the power supply voltage of the "electronic control board" when unloaded is DC12.8 volts.

 

4、 What should I do if there is no image displayed during the luggage inspection of the thermal imaging temperature measurement gate machine?

 

1. Check if the DB9 on the "COM1" serial port behind the industrial computer is loose. If it is loose, please tighten it.

2. Check if the "COM1" serial port of the industrial computer is damaged - if it is damaged, replace the serial port and the corresponding serial port position in the software;

3. Check if the power supply voltage of the "electronic control board" when unloaded is DC12.8 volts.

 

V The system information prompts "communication interruption", "connection failure", and "byte 0". How to solve this problem?

 

1. Check if the "Ethernet cable, USB cable, and power cable" of the gearbox are loose or disconnected. If loose or dropped, please tighten again;

2. Check if the "Universal Serial Bus" cable behind the industrial computer is loose or detached. If loose or detached, tighten again.